Centrifugal clutch

Product features:

• Self increasing clutch
• Installed with 3 clutch shoes
• Needle bearing with brass support
• Extreme narrow design
• Low maintenance, Lightweight
• Copper bushing
• No modification required

How to put it in a vehicle?

1. Apply some grease on output shaft of the engine, then put key of 5 mm x 2.5 mm on engine's output shaft key-way.
2. Apply some grease on the inner side of centrifugal clutch, Now orient it as such to properly sync both key-ways i.e. of engine & of clutch. (A 5 mm x 2.5 mm key-way is provided in centrifugal clutch housing which perfectly matches with engine shaft key-way)
3. Gently punch centrifugal clutch on engine shaft, after punching it to extreme end of key-way, stop. (Advice: Use mallet hammer to punch centrifugal clutch)
4. Tight centrifugal clutch with provided washer, bolt must be fine thread and  of 1 inch in length.(Bolt type: M8, i.e. with outer diameter of 8 mm)